Cheap Varistors or Expensive TVS-diodes?

Authors

  • Vladimir Gurevich

DOI:

https://doi.org/10.22385/jctecs.v18i0.268

Keywords:

varistort, TVS-diode, supressor, HEMP, EMP

Abstract

Varistors and suppressors (TVS-diodes) are well-known and widely-used in electronic equipment as components providing voltage surge protection. For very powerful but very short-lasting pulses of the nanosecond range, with steep raising edge (such as HEMP pulses), the suitability of varistors and TVS-diodes is questionable. Since the technical community did not reach any shared vision regarding this point, the author performed its own tests described below.  

Downloads

Download data is not yet available.

References

Protection Technology Comparison Chart. – Protek Devices, 2013.

TND335/D. Transient Overvoltage Protection, ON Semiconductor, Semiconductor Components Industries, LLC, 2008

Electronics, protection against overvoltages. Paragraph Н. 51. Basics of overvoltage protection. – Weidmuller.

AN 1826/0104. Transient Protection Solution: Transil™ diode versus Varistor /Bremond A., Karoui C. – STMicroelectronics.

S. J. Goldman, Selecting Protection Devices: TVS Diodes vs. Metal-Oxide Varistors, Power Electronics, June 1, 2010.

Han S. M., Huh C. S., Choi J. S. A Validation of Conventional Protection Devices in Protecting EMP Threats. – Progress in Electromagnetic Research, 2011, Vol. 119, pp. 253 – 263.

Howell T. Comparing Circuit Protection Technologies for 48 V DC in High Surge Environments. – Protection Engineers Group Conference, Dallas, March 14 – 16, 2017.

Gurevich V. The Problem of Correct Choice of Ferrite Beads – Electrical Engineering & Electromechanics, 2016. No. 2, pp. 71- 75.

Downloads

Published

2018-09-03

Issue

Section

Articles